Aluminium Flagpole

flagpole icon [Converted]Aluminium last longer and more corrosive resistant, unlike steel, aluminium does not rust or deteriorate over time. We design our aluminium flagpole base 4 major factor: size, height, thickness and flag size, all flagpole design comply with standard set by NAMM.

RGDI’s flagpole shafts using 6063-T6 aluminium having a tensile strength not less than 207 MPa and yield stress of 172 MPa. Following the tapering and heat treating process, the flagpole shafts are brush polished and following with anodizing process or powder coating, depend on requirement.

Flagpole is not complete with the essential accessories such as finial, internal clamp, external cleat, all component have been tested for it durability and strength, you can refer to our accessories page here.

We offer taper, straight both for conventional flagpole and banner flagpole. The tapered poles are wider at the base than at the top, and straight shafts are the same diameter from top to bottom. Each of the above referenced styles may be purchased with an internal or an external halyard. The halyard is the rope that is used to raise and lower the flag. Internal halyard poles have the rigging on the inside of the pole, while external has the rigging on the outside of the pole.

Flagpole below 12M height be default in single section, height beyond this will ship in 2 sections and above depend on requirement.

Our product range:

 

 

  • Banner Aluminium Flagpole
    Outdoor Fixed Arm with Fixed base
    Outdoor Fixed Arm with Hinged base
    Outdoor Fixed Arm with Tension bar and Fixed base
    Outdoor Fixed Arm with Tension bar and Hinged base
    Outdoor Swing Arm with Rotating Pole

 

  • Wall Mount Aluminium Flagpole

 

  • Wind drive Aluminium Flagpole
    Need specify the 3 phase voltage during inquiry, by default the voltage is 380V.